Trimble R6 User Manual

TrimbleR6/R7GPSandTrimbleR8GNSSReceiversUserGuide 145
Symbols
d 10, 28
p 10, 28, 90
$ (NMEA start of message delimiter) 126
* (NMEA checksum delimiter) 127
, (NMEA field delimiter) 126
.cfg files 38–41, 47, 98–101
.dat files 45–47
.elf files 36, 47, 95
.eph files 47
.T01 files 45, 46, 47
Numerics
1PPS output
default settings 60
pulse definition 73
time tag definition 73
Trimble R7 GPS receiver 6, 57, 73
A
accuracy
centimeter-level 6, 78
submeter-level 6, 78
Actual Track Made Good Over and Speed Over
Ground message 136
adding frequencies for internal radio 52, 106
ANT port 13
antenna information, default 60, 116
Antenna record, in application file 38, 98
antennas
electrical interference 14, 84
mounting 14, 84
RPA 20
rubber duck 16, 20
using with the Trimble R7 GPS receiver 69
whip 16, 20
Zephyr 17
Zephyr Geodetic 17
application files
applying 41, 100
configuring the receiver with 98
Current (Current.cfg) 39, 59, 99, 115
Default (Default.cfg) 39, 59, 99, 115
deleting 28, 90
deleting by formatting CompactFlash card 32
maximum number 39, 99
naming 42, 101
overview 38, 98
power up (Power_up.cfg) 40, 59, 100, 115
records 38, 98
storage of 41
storing 41, 100
timed 29, 40, 63
applying application files 41, 100
ASCII
output, default settings 60, 116
time tags, default 60
time tags, definition 73
Australia
notices to users ii
B
backpack setup 20
base station See reference station
baseline, moving 126
batteries
camcorder 23
charging in reference and rover receiver at the
same time 34
charging while in Trimble R7 GPS receiver 33
charging with TSCe batteries 35
minimum power to charge 33
operating time 33, 56, 112
standby 30
battery
compartments 11, 13, 84
inserting in the Trimble R6/R8 receiver 85
LEDs 30
baud rate
default 60, 116
maximum 57, 113
binary output, default settings 60, 116
blue RPA cable 13
blue TNC port 13
Index

Trimble R6 Specifications

General

Brand	Trimble
Model	R6
Category	GPS
Language	English