CHAPTER
9
Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide 59
Default Settings 9
In this chapter:
Q Default settings
Q Resetting to factory defaults
Q Examples
All Trimble R7 GPS receiver settings are stored in
application files. The default application file,
Default.cfg, is stored permanently in the receiver,
and contains the factory default settings for the
Trimble R7 GPS receiver. Whenever the receiver
is reset to its factory defaults, the current settings
(stored in the current application file, current.cfg)
are reset to the values in the default application
file.
You cannot modify the default application file.
however, if there is a power up application file
(Power_up.cfg) in the receiver, the settings in this
file can be applied immediately after the default
application file, overriding the factory defaults.
For more information, see Application files,
page 38.
To Next Page
Loading...