TRIMOS V7 - SENDING DATA AND PRINTING; Configuring the Printing and the Data Transfer

V7 / V9
750 50 0042 03 63
12. SENDING DATA AND PRINTING
12.1 Connectors
The instrument offers the following communication ports:
1 x USB B
This connector is placed at the back of the display unit. It
allows connection to a PC for the transmission of data.
4 x USB A
These connectors are placed at the back of the display
unit. They allow connection to peripherals such as USB
key or USB printer.
1 x RJ45 Ethernet
This connector is placed at the back of the display unit. It
allows the configuration of USB printers.
1 x RS232
This connector is placed at the back of the height gauge.
It allows a classic connection with external devices
equipped with RS232 interfaces, such as printer or PC.
12.2 Configuring the Printing and the Data Transfer
1. Activation/selection of the USB printer (for configuring
the printer, refer to § 12.5.1)
2. Activation of serial printing and PC (Simultaneous
transfer on the RS232 and USB B ports)
3. Data transfer with line no., function and unit
4. Data transfer with numeric value only
5. Diameter and centreline distances:
Select the value (s) to be sent when the
Data transfer
key
is pressed for the first time.
6. Diameter and centreline distances:
Select the value (s) to be sent when the
Data transfer
key
is pressed for the second time.
>2 s
Factory configuration of
the printing
1
2
3
4
5
6
7