V7 / V9
750 50 0042 03 71
14. ADJUSTMENTS
14.1 Configuration diameter measurements "SMART REVERSE"
The Smart Reverse function facilitates the measurement
of diameter and makes it more efficient and playful. By
activating this function, the user is visually warned by a
colour "flash" on the screen as well as by a specific
acoustic signal that the reversal point has been reached.
It is possible to set this function by pressing the diameter
key for 2 seconds:
1. Activation box for the
function.
2. Number of passes required to validate the reversal
point.
3. Surface quality of the measured diameter. This
function makes it possible, during several passes of
the reversal point, to ensure that this has been
reached. This parameter analyses the difference
between the extreme values of the reversal point and
compares them to validate the measurement.
- ROUGH: Raw surfaces rapidly measured
- MEDIUM: Machined surfaces normally measured
- SMOOTH: Polished surfaces delicately measured
4. Beep indicating the detection of the reversal point
Note:
Parameters 3 and 4 are only accessible when the
number of passes of the reversal point (defined in
point 2) is greater than 1.
5. Colour of the flash on the screen when detecting the
reversal point.
> 2s
Note 1:
In diameter mode, when the Smart Reverse function is
activated, the symbol of the diameter function is
changed (red arrows).
Note 2:
When the graphical help is displayed, the number of
detected reversal points is displayed next to the probe
indicator.
In Smart Reverse mode, the diameter measurement must start at the bottom. This is
valid for internal and external measurements.
To Next Page
Loading...
Need help?
General
