V7 / V9
750 50 0042 03 27
7.6 Probe Constant
7.6.1 Recording of the Probe Constant
To check and memorise the probe constant, press the key
shown alongside and follow the same sequence as for
"Setting into operation" (§ 4.3, points 2 to 7).
Note:
The current constant value is shown on the first line of the
display by pressing this key once. A second pressure
interrupts the acquisition of constant and brings the
instrument back into height measuring mode.
7.6.2 Probe Constant Library
8 probe constants can be stored.
To access the list, press the probe constant key for 2
seconds.
To select the constant to use, press the number from 1 to
8. The active constant is marked in green.
It is also possible to manually change the value of each
probe constant.
> 2 s
When another constant than the No. 1 is activated, a
symbol is displayed in the status bar.
To define a new value of the active constant, follow the
same procedure as when starting (§ 4.3, points 2 to 7).
The constant is an essential element during bidirectional measurements. Great
caution is essential while interpreting the measurements results when this value is
entered manually.
To Next Page
Loading...
Need help?
General
