Model 3440-L 6–23
6. SPECIAL FUNCTIONS
If the gauge is in the correct position, press 〈START/ENTER〉. The
display will be:
Precision Mode
Depth: xx
Time: xx sec
1-min. count
After counting down to zero, the display will be:
xx min. to
reach precision.
Want to begin?
Press CE to exit
Press 〈YES〉. After counting down, the display will be:
(For Soil mode)
%PR= xxx %
DD= xxx
WD= xxx
M= xx %M= xx
(For Asphalt mode)
%MA= xxxx %
WD= xx
NOTE
If the required precision cannot be reached in 60 minutes, the
following screen will be shown displayed.
-WARNING-Time to
reach precision
too high!
Press CE to exit
The precision mode will remain enabled until the gauge is turned off for
more than ten seconds.
To Next Page
Loading...
