2–6
MODE SELECTION
The Mode function provides for the selection of Soil or Asphalt mode.
Under Asphalt mode, the sub-mode selection of % Marshall or % Voids
may be enabled.
Also, while in Asphalt mode, the % Voidless density selection may be
enabled.
To select the Mode function, press 〈SHIFT〉 and 〈MODE〉 for the display:
MODE: SOIL
Select: 1- SOIL
2- ASPHALT
(CE to exit)
Soil Mode Selection
From the above display, press 〈1〉 to select Soil mode. The display is:
SOIL MODE
After a short delay, the display will return to READY. Chapter 4 provides
instructions for taking measurements in Soil mode.
Asphalt Mode Selection
From the first display on this page, press 〈2〉 to select Asphalt mode.
The display will be:
ASPHALT - %MA
Select: 1- %MA
2- 100-%MA
(CE to exit)
To Next Page
Loading...
