TUG Technologies 660 - Receiving; Preparing for Operation; Battery; Emergency Hydraulic Pump

Mobile Belt Loader Model 660 Operation
Operation Manual
Operation - 4 - 48 CD397-Oper
4.2Receiving
4.2.1PreparingforOperation
4.2.1.1Battery
• Connect battery terminals to battery posts.
4.2.1.2EmergencyHydraulicPump
1. Use emergency hydraulic pump to raise conveyor, if required.
2. Insert safety props.
4.2.1.3Radiator
1. Make certain that radiator drain valve is closed.
2. Add required amount of coolant / water mixture to radiator.
4.2.1.4FuelCell
1. Add fuel to fuel tank.
2. Check all fuel lines for leaks.
WARNING: MAKE CERTAIN ALL FUEL LINES ARE PROPERLY CONNECTED
FROM TANK TO FUEL PUMP TO FUEL RAIL (GASOLINE) OR INJECTOR
PUMP (DIESEL).
WARNING: WHEN SHIPPED TO THE EUROPEAN UNION, THE BELT
LOADER WILL NOT BE FITTED WITH LP TANKS.
NOTE:
For the LP engine option, the vehicle is built in the United States with non-EU com-
ponents and tested to US standards. These components are removed prior to ship-
ment to EU destinations.