TUG Technologies 660 - Operational Engine - Unable to Move

Safety Mobile Belt Loader Model 660
Operation Manual
CD397-Oper Safety - 1 - 9
2. Turn on the emergency hazard warning signals.
3. If unable to move the tow tractor out of the traffic area and when visibility is limited, set out
one type of emergency warning device (i.e. red cones, etc.) to the front and rear of the
unit.
1.7.1.2OperationalEngine-UnabletoMove
When the engine is operable but the unit cannot be moved, perform the following steps:
1. Use a tow bar to attach the disabled unit to an operational tow tractor.
2. Release the park brake.
3. Ensure steering is operational in the disabled unit by turning the steering wheel.
4. Tow unit.
5. Once towing destination is reached, place transmission of the towing vehicle in neutral,
apply the park brake, and turn the ignition key to the OFF position.
6. Chock wheels of the disabled unit.
7. Disconnect the vehicles by removing the tow bar.
CAUTION: Turn on headlights when/if visibility is limited.
NOTE:
The disabled unit should be steered to follow the towing unit.
CAUTION: CAUTION: Towing speed must NOT exceed 6 mph (10 km/h). Do
NOT tow the disabled unit more than 6 mi. (10 km).