Mobile Belt Loader Model 660 Operation
Operation Manual
Operation - 5 - 56 CD397-Oper
11. Clean exterior surface of engine.
12. Seal all openings in engine and accessories with non-hygroscopic material.
13. Mask off (seal) all areas with electrical contacts.
14. Ensure all surfaces are dry
15. Spray all taped openings, all engine accessories, including ignition wiring, and all exterior
surfaces of engine with Insulation Compound.
16. Loosen belt tension.
17. Apply multipurpose grease on moving parts such as rod threads, linkage, and joints.
18. Check all openings of the engine to ensure that plastic covers are in place and sealed.
19. Secure a waterproof cover over the engine
5.3.8Transmission
Refer to the manufacturer's recommendation contained in the transmission service manual in the
maintenance manual.
5.3.9DriveAxle
1. Drain drive axle by removing drain plug located on the underside of the differential carrier
housing.
NOTE:
Use volatile corrosion inhibitors (VCI) (NOX-RUST VCI#10 oil), black or dark col-
ored plastic bags, and sealing tape (Kendall No. 231) to prevent internal engine
damage from moisture. Use an air compressor with a sprayer attachment to apply
oil. After application, completely seal the engine to prevent the vapors from escap-
ing. For information on VCI, contact:
Customer Service
Daubert Chemical Co.
4700 S. Central Avenue
Chicago, Illinois 60638
Telephone: (800) 688-0459
Fax: 708-496-7367
Outside U.S.: 708-496-7350
http://www.daubertchemical.com
NOTE:
Remove the waterproof cover every 2 to 3 months and check the engine for corro-
sion and integrity of its sealed areas. If any sealed system appears open, refer to
the appropriate system and repeat the application.
To Next Page
Loading...
