TUG Technologies 660 - Exhaust; Tires; Lubrication; Levels

Operation Mobile Belt Loader Model 660
Operation Manual
CD397-Oper Operation - 5 - 57
2. Reinstall plug after draining.
3. Attach a tag on steering wheel stating:
5.3.10Exhaust
1. Disconnect the exhaust system at the engine exhaust manifolds.
2. Use a sprayer to apply a mixture of 50% VCI oil and 50% engine oil into the exhaust man-
ifold openings.
3. Connect the exhaust system.
4. Seal the exhaust pipe with tape and plastic.
5.3.11Tires
1. Raise the vehicle and chock the axles to prevent tire contact with ground.
2. Reduce air pressure to 15 psi (103.42 Kpa or 1.02 atm).
3. Spray tires with a rubber preservative.
5.3.12Lubrication
Ensure all points are lubricated with specified grease, oil, etc. (See Ch.2, Sect. 1 in Maintenance
Manual)
5.3.13Levels
Service all fluid levels.
5.3.14WheelBearings
Repack wheel bearings.
5.3.15Battery
1. Disconnect the battery cables.
CAUTION: Oil has been removed from drive shaft.
NOTE:
A minimum application is 2 oz (60 ml).
WARNING: TO AVOID INJURY TO PERSONNEL OR DAMAGE TO EQUIP-
MENT, ALWAYS USE LIFTING EQUIPMENT, JACK STANDS, AND CHAINS
WITH A SAFE MINIMUM CAPACITY OF ONE AND A HALF TIMES THE
WEIGHT OF THE VEHICLE BEING LIFTED.