Operation Mobile Belt Loader Model 660
Operation Manual
CD397-Oper Operation - 5 - 55
5.3.7DieselEngine
5.3.7.1Deutz2.9LEngine
CrankcaseandFilterElements.
1. Run engine until reaching normal operating temperature.
2. Turn the engine off.
3. Drain oil from crankcase.
4. Replace the oil filter.
5. Re-fill the engine with new oil.
6. Add 3 to 4% of VCI.
7. Place and seal the plastic cover over the dipstick and the crankcase breather.
8. Use tape to seal any openings.
9. Drain antifreeze from radiator and engine block (excluding Deutz diesel units).
10. Attach a tag on steering wheel stating,
NOTE:
Oil filter elements do not need to be changed if the engine oil has been used 50
hours or less, leave it in the sump and add 3 to 4% by volume of VCI.
If the oil has more than 50 hours of use, change the oil.
CAUTION: Oil will be hot.
CAUTION: Oil and antifreeze have been removed from engine.
To Next Page
Loading...
