Mobile Belt Loader Model 660 Safety
Operation Manual
Safety - 1 - 10 CD397-Oper
1.7.1.3InoperableEngineWithElectricalPower
When the engine is inoperable it will experience loss of power.
1. Release the park brake.
2. Engage the emergency hydro-steering pump by holding the toggle switch. Release the
toggle switch to disengage or shut off the hydro-steering pump.
3. Ensure steering is operational in the disabled unit by turning the steering wheel.
4. Tow unit.
5. Once towing destination is reached, place transmission of the towing vehicle in neutral,
apply the park brake and turn the ignition key to the OFF position.
6. Chock wheels of the disabled unit.
7. Disconnect the vehicles by removing the tow bar.
1.7.1.4InoperableEngineWithLossofElectricalPower
An inoperable engine will experience loss of electrical power. When there is not enough electrical
power to engage the emergency steering pump, perform the following steps:
1. Use a tow bar to attach the disabled unit and an operational tow tractor.
2. Release the park brake.
CAUTION: Engaging the emergency hydraulic pump for more than one min-
ute will cause the electric motor to overheat. If emergency procedures can-
not be completed within one minute, disengage and allow the pump to cool
for at least 10 minutes before re-engaging. Failure to comply may result in
vehicle damage.
NOTE:
Steer the disabled unit to follow the towing unit.
CAUTION: Towing speed must NOT exceed 3 mph (5 km/h). Do NOT tow the
disabled unit more than 6 mi. (10 km).
CAUTION: Towing speed must NOT exceed 3 mph (5 km/h). Do NOT tow the
disabled unit more than 6 miles (10 km). The disabled unit will be difficult to
steer as there is no hydraulic pressure available.
To Next Page
Loading...