Operation Mobile Belt Loader Model 660
Operation Manual
CD397-Oper Operation - 5 - 59
5.3.18Tagging
Fasten a tag to the starting switch on the control panel stating:
5.4ReturningtheVehicletoOperationAfterLong-TermStorage
5.4.1Tires
1. Inflate the tires to 45 psi (310 kPa or 1.06 atm) - Standard.
2. Using a forklift or a crane, lift the unit.
3. Remove the blocks from beneath the tractor.
4. Lower the tractor to the ground.
5.4.2Battery
1. Check the battery levels and service them, if required.
2. Install the batteries in the vehicle.
3. Clean the battery cables and posts.
4. Lightly coat the clamps and the battery posts with petroleum jelly.
5. Connect the battery cables to the posts.
6. Charge the batteries.
5.4.3Engine
1. Remove the plastic covers and tape from all engine and fuel tank openings.
2. Drain the oil sump, if needed.
3. Replace the filters, if needed.
4. Refill the oil sump.
5. Tighten the alternator and water pump belt.
WARNING: DO NOT START THE ENGINE! UNIT IN STORAGE! ALL SYS-
TEMS DRAINED OR PRESERVED!
WARNING: TO AVOID INJURY TO PERSONNEL OR DAMAGE TO EQUIP-
MENT, ALWAYS USE LIFTING EQUIPMENT, JACK STANDS, AND CHAINS
WITH A SAFE MINIMUM CAPACITY OF ONE AND A HALF TIMES THE
WEIGHT OF THE VEHICLE BEING LIFTED.
To Next Page
Loading...