Mobile Belt Loader Model 660 Operation
Operation Manual
Operation - 2 - 18 CD397-Oper
1. Fuel Level
2. Tire Inflation
3. Engine Oil Level
4. Transmission Oil Level
5. Seatbelt Serviceability
6. Service Brake Effectiveness
7. Parking Brake Effectiveness
8. Vehicle Drive Forward
9. Vehicle Drive Reverse
10. Check the hydraulic fluid level with the conveyor down
11. Conveyor Belt Drives in Forward direction
12. Conveyor Belt Drives in Reverse direction
13. Front Cylinder Extension: Raises front of conveyor
14. Front Cylinder Retraction: Lowers front of conveyor
15. Rear Cylinder Extension: Raises back of conveyor
16. Rear Cylinder Retraction: Lowers back of conveyor
17. Verify all "E" Stops function correctly
2.1.7ManeuveringProcedures
Procedures for maneuvering the vehicle to an aircraft are outlined below:
2.1.7.1EngineStartProcedure(Gas)
1. Apply parking brake.
2. Move transmission selector to Neutral. (Starter motor will not activate unless selector is in
Neutral).
WARNING: OBSERVE ALL SAFETY PRECAUTIONS DISCUSSED IN THE
SAFETY SECTION OF THIS MANUAL.
To Next Page
Loading...