Mobile Belt Loader Model 660 Operation
Operation Manual
Operation - 5 - 54 CD397-Oper
5.3.2.1DriveAxle
1. Drain drive axle by removing drain plug located on the underside of the differential carrier
housing.
2. Reinstall plug after draining.
3. Attach a tag on steering wheel stating:
5.3.3Tires
1. Raise the vehicle and chock the axles to prevent tire contact with ground.
2. Reduce air pressure to 15 psi (103.42 Kpa or 1.02 atm).
3. Spray tires with a rubber preservative.
5.3.4Lubrication
Ensure that all points are lubricated with specified grease, oil, etc.
1. Repack wheel bearings.
2. Drain crankcase completely and renew the oil filter.
3. Drain antifreeze from radiator and engine block.
5.3.5FluidLevels
All fluid levels should be serviced, as necessary.
5.3.6Battery
Remove the battery and store separately. Store in a cool dry place not in direct sunlight. Maintain
storeroom temperature from 32° F (0° C) to 90° F (32° C). If stored outside, cover the battery for
protection against dirt and moisture. Slow charge the battery every one to two months.
CAUTION: Oil has been removed from the drive axle.
To Next Page
Loading...
