Operation Mobile Belt Loader Model 660
Operation Manual
CD397-Oper Operation - 5 - 51
5.1.2.4Tires
1. Using a forklift or a crane, raise the vehicle
2. Chock the axles to remove tire contact with the ground.
3. Reduce tire pressure to 15 psi (103.42 Kpa or 1.02 atm).
5.1.2.5Lubrication
Ensure that all points are lubricated with specified grease, oil, etc.
5.1.2.6Battery
Disconnect battery terminals. Keep the battery fully charged during storage.
5.1.2.7FluidLevels
All fluid levels should be checked and topped off as necessary.
5.2ReturningtheVehicletoOperationAfterShortTermStorage
5.2.1Tires
1. Check the tire pressure.
2. Use a forklift or a crane to lift the vehicle off the chocks.
3. Remove the blocks from beneath the vehicle.
4. Lower the vehicle to the ground.
5.2.2Battery
1. Clean the battery posts and cable clamps.
WARNING: TO AVOID INJURY TO PERSONNEL OR DAMAGE TO EQUIP-
MENT, ALWAYS USE LIFTING EQUIPMENT, JACK STANDS, AND CHAINS
WITH A SAFE MINIMUM CAPACITY OF ONE AND A HALF TIMES THE
WEIGHT OF THE VEHICLE BEING LIFTED.
NOTE:
If required, inflate tires to 45 psi (310 kPa) - Standard.
WARNING: TO AVOID INJURY TO PERSONNEL OR DAMAGE TO EQUIP-
MENT, ALWAYS USE LIFTING EQUIPMENT, JACK STANDS, AND CHAINS
WITH A SAFE MINIMUM CAPACITY OF ONE AND A HALF TIMES THE
WEIGHT OF THE VEHICLE BEING LIFTED.
To Next Page
Loading...
