TUG Technologies 660 - Unit Identification Plate

CD397-Oper Introduction - 1 - 1
Mobile Belt Loader Model 660
Operation Manual
Introduction
UNITIDENTIFICATION
The information and instructions in this manual are intended to acquaint the operator with the
important operating features of the TUG Mobile Belt Loader Model 660. The various controls,
gauges, switches, and operating features are explained and illustrated throughout this manual.
Personnel responsible for operation of the vehicle should read this manual carefully.
To aid the technician in repair or service work on this unit, a TUG identification plate is located in
the operator's compartment.
The serial number identification of each unit will appear on the nameplate along with the date of
manufacture. The mailing address of TUG is also located at the top of the data plate opposite
the TUG logo. This necessary information will ensure the customer a fast and accurate response
to any parts and/or service request.
Please verify the serial number on the identification nameplate of the unit and enter your unit
serial number here:
______________________________________________________
If applicable, enter your company identification number here:
______________________________________________________________________
SERIAL
NUMBER
3,175
3,266
40
907
227500
2,000
25
7,200
7,000
KILOGRAMS
POUNDS
KILOGRAMS
POUNDS
660−4−3728
KPH
KILOGRAMS
KILOGRAMS
MPH
POUNDS
POUNDS
MAXIMUM SINGLE LOAD ON THE BOOM IS
PERMISSABLE TOTAL PAYLOAD EVENLY DISTRIBUTED ON THE BOOM AT MAXIMUM AND MINIMUM ANGLE IS:
MAXIMUM SPEED
WITH CAB
UNLADEN WEIGHT w/OUT CAB
MFG DATE
MODEL #
TUG TECHNOLOGIES CORPORATION
1995 DUNCAN DRIVE
KENNESAW, GEORGIA 30144
FigureIntroduction-1-1:TUGIdentificationPlate