Mobile Belt Loader Model 660 Operation
Operation Manual
Operation - 5 - 58 CD397-Oper
2. Remove the battery and store separately.
3. Slow charge the battery every one to two months.
5.3.16FuelSystem
1. Drain the fuel tank.
2. Use a sprayer to apply 1 oz (30 ml) of VCI oil for each 7.50 gal (30 L) of tank capacity.
3. Seal the tank opening.
4. Remove the fuel filter, drain, and reinstall.
5. Clean the primary fuel filter (if equipped).
6. Remove the fuel injectors, check them, and recondition them, if necessary.
7. Spray 1 oz (30 ml) of 50% VCI oil and 50% engine oil in each cylinder.
8. Install the fuel injectors and tighten them to 30 ft/lb (40 Nm).
9. Using a bar or turning tool, turn the engine over slowly to lubricate the cylinder walls.
5.3.17EngineExterior
1. Apply multipurpose grease on moving parts such as rod threads, linkage, and joints.
2. Check all openings of the engine to ensure that plastic covers are in place and sealed.
3. Secure a waterproof cover over the engine.
NOTE:
Store the battery in a cool dry well ventilated area not exposed to direct sunlight.
A recommended storeroom temperature of 32° F (0° C) to 90° F (32° C) should be
maintained. If stored outside, cover the battery for protection against dirt and mois-
ture.
NOTE:
Remove the waterproof cover every 2 to 3 months and check the engine for corro-
sion and integrity of its sealed areas. If any sealed system appears open, refer to
the appropriate system (listed above) and repeat the application.
To Next Page
Loading...
