169
169
Tread wear marks are integrated into the main grooves
on every tyre. If the tyre tread has worn down to the
level of the marks, the tyre is completely worn. The
location of the tread wear marks are indicated by an aero
mark on the edge of the tyre (ref. Fig. 60). Replace the
tyre when the minimum tread depth is reached.
Note
• Tread depth of the tyre should be minimum 2 mm
if the vehicle speed is higher than 100 km/h, and
it shall be minimum 1 mm if the vehicle speed is
lesser than 100 km/h.
Tread depth (min) :
2 mm (> 100 km/h)
1 mm (< 100 km/h)
Visually inspect the tyres at regular intervals for cracks
and cuts, especially on the side walls, and bulges or
large stains that indicate internal damage. Replace them
if damaged.
Remove any stones or other foreign bodies stuck in the
tread.
Tyre replacement
• The tyres fitted on your motorcycle were designed
to match the performance capabilities of your
motorcycle and provide the best combination
of handling, braking durability and comfort. The
recommended tyres for your motorcycle are:
A
Fig. 60
Front
MICHELIN M/C 54 H Tubeless
110/70 ZR17 M/C 54 W Tubeless
Rear
MICHELIN M/C 66 H Tubeless
150/60 ZR17 M/C 66 W Tubeless
R
O
T
A
T
I
O
N
To Next Page
Loading...
Need help?
General
