170
Side walls of the tubeless tyres which are in contact with
the wheel rim are only seals the air inside the wheel
assembly. Hence, care should be taken not to damage
the side walls of the wheel rim during removal and
reassembly of the tyres.
Have the tyres replaced at only TVS Motor Company
Authorised Main Dealer or Michelin Authorised Dealer.
Proper removal and reassembly of wheels and the tyres
are essential.
Use only the recommended tyre. Use of a tyre other
than the standard will cause instability. Be sure the
wheel is balanced after the new tyre is installed.
• While re-assembling the tyre, ensure that the
arrow mark (1) provided on the side walls of the
tyre faces the direction of wheel rotation (ref.
Fig. 60).
Wheel balancing to be done every 1 year or every
10000 km. In addition, after every tyre puncture repair
or replacement, wheel balancing to be done without fail.
Do not remove or alter the position of wheel balancing
weights after the completion of wheel balancing.
Do not repair the punctured tyre. It should be replaced.
If it is necessary to run the vehicle on a repaired tyre,
never exceed 100 km/h speed until the tyre is replaced.
Never install a tube inside a tubeless tyre on this
motorcycle. The tube may get burst during ride due
to excessive heat buildup which will result in serious
consequences.
Since the rims of this motorcycle is designed for tubeless
tyres, use tubeless tyres only. During hard acceleration
or braking, a tube tyre could slip on the rim and deflate
rapidly.
Warning
Tyre repair
• Do not repair the punctured tyre and it should
be only replaced. If it is necessary to ride on a
repaired tyre, never exceed the vehicle speed
above 100 km/h until the tyre is replaced.
To Next Page
Loading...
Need help?
General
