5-35
i. As the drive pinion and the ring gear make a
pair, be sure not to mate them with other
parts from differential tractors.
ⅱ. Adjust the shimming to backlash of 0.1-0.25
mm (0.004-0.009 in).
The standard shimming is 0.5mm (0.016 in) on
both sides.
Note :
When reassembling the used pinion and ring
gear, reinstall the same thickness of shims as was
installed before disassembly in each shimming
position.
h. Backlash adjustment between the drive pinion
and the ring pair (Fig5-65)
Fig.5-66
To Next Page
Loading...
