2) REAR TRANSMISSION
(1) DRIVE PINION & RING GEAR
Starting torque 0.11-0.13 ㎏f·m
Backlash 0.1 ∼ 0.2 ㎜ 0.5 ㎜ Backlash and tooth
bearing should be
adjusted properly
when reassembled
Drive pinion and
ring gear support
shimming
Adjustment of relative positioning
between drive pinion and ring gear
Available shims on drive pinion
metal(support)
Shim A : 0.1 ㎜ (0.004 in)
Shim B : 0.2 ㎜ (0.008 in)
Available shims on dif-case
Shim A : 0.1 ㎜ (0.004 in)
Shim B : 0.2 ㎜ (0.008 in)
11-4
Part names and
inspection items
Nominal
dimensions
Standard value
for reassembly
Usable limits Service instructions
and remarks
(2) DIFFERENTIAL
Backlash between
dif-pinion and
dif-side gear
0.1 ∼ 0.25 ㎜ 0.5 ㎜ Worn pinion thrust
collar or gear
Right and Left dif-side
gears are refined
differently from each
other,so take care not
to interchange them
when assembled
To Next Page
Loading...
