e. Sub-assembly of the sleeve metal with the release bearing and the drive shaft
Fig.5-30
5-15
31 42 5
9
7
8
6
1. Sleeve metal
2. Oil seal (D)
3. Sleeve
4. Release bearing
5. Spring
6. Bearing
7. O-ring
8. Sleeve metal Sub assembly
9. Bolts
(3) installation of the reverse metal and related parts.
Reassemble in reverse order of disassembly, following the next instructions.
a. Install the reverse metal sub-assembly from the spacer transmission referring to the description
(Fig 5-27), (Fig.5-30), (Fig.5-31), (Fig.5-32)
b. Oil seals should be installed in their correct direction., be careful not to interchange these seals.
c. Apply grease to the O-ring and the oil seal, the needle bearing to prevent its damage.
Note : Apply grease to the O-ring and the oil
seal
Fig.5-31 Reverse metal sub-assembly
To Next Page
Loading...
