u-blox ANTARIS 4 - Page 117


your position is our focus
4.8.1.4 Change Configuration permanently
Tochangeaconfigurationpermanentlyonthereceiver,theconfigurationparametersmusthavebeenpreviously
atstartup.Thereforeanypermanentchangeofconfigurationmustbesavedinthe
CostreceiversorFLASHforProgrammableReceivers.
storedinordertobeavailable
batterybackupRAMforLow
Tostoreaconfiguration
selecttheUBX–CFG(Config)–CFG(Configuration)savecommandinu-centerAEand
sendthemessagetothereceiverbypressingthesendbutton(
).

Figure 92: Saving a configuration section
 Note Usethe<ctrl>+<leftclick>todeselectthelastselection,ifyouchoose“userdefined”.
4.8.1.5 Loading a Configuration
Generallythereisnoneedtomanuallyloadconfigurationsettingssincetheyareautomaticallyloadedatstartup.
Theabilitytoforcealoadofthesettingscanbeusefulifyouchangedsome
settings(withoutsaving them)and
wanttoreset the configuration to thelast saved configuration. To dothis select the requested sectionsin the
loadboxandsendthemessagetothereceiver.
4.8.1.6 Clear a Configuration permanently
Clearingaconfiguration canbeusefulifyouwanttoresettothefactorydefaultstate.Youhave toloadthem
afterwardstobecomeeffective.
 Note This operation onlyclears theconfiguration Memory.Itdoesn‘t reapplydefaults. Youneedto doa
„Load“orrestartthesysteminordertoloadthedefaults.
 Note WhenselectingsectionsintheClear,SaveandLoadboxConfigurationisfirstcleared
thensavedand
finallyreloaded.
GPSModules-SystemIntegrationManual(SIM)(incl.ReferenceDesign) ReceiverDescription
GPS.G4-MS4-05007-A1
  Page 117