EasyManua.ls Logo

u-blox ANTARIS 4 - Page 76

u-blox ANTARIS 4
187 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
your position is our focus
4.3.4.1 Short and Ope it Active Ant
ection o es to TIM-4x and LEA-4x receiv ption o
Antenna rvisorc onfiguredbya (usingonlyUBXbinarymessage).
en enable active a supervisor p t messag (status reporting in NMEA and/or
inaryp )whic atesallchange rcuitry(disabledantennasupervisor,antenna
uitryok,
ircuit, t)andshu lydown
tivean supervisorprovidesthemeans eanten circuitsandto
antennasupplyoff,ifashortcircuitisdetec
stateafter
power-upis“ActiveAntennaOK”.
n Circu enna Supervisor
This s nly appli ers with the exce f LEA-4M.
The Supe anbec serialportmessage
Wh d the antenn roduces serial por es
UBXb rotocol hindic softheantennaci
circ
shortc opencircui tstheantennasupp ifrequired.
Theac
shutthe
tenna tochecktheactiv
ted.
naforopenandshort
Thefollowingstatediagramapplies.Theinitial
No
Super-
vision
Active
Antenna
OK
Open
Circuit
d tedetec
Short
Circuit
Powerup
SCND_N
User controlled events
Enable Supervision
Short Circuit
FW <5.00:
Reset,
Powercycle
Events AADET_N, AA_
Disable Supervision
detected
Supervision
open circuit
detected, given
FW >=5.00:
Periodical
reconnection
attempts
Disable
No longer short
circuit
OCD enabled
op
Short Circuit
detected
detected
tional
ailable on LEA-4M and NEO-4S. However, both modules still output antenna
d.
Figure 64: State Diagram of Active Antenna Supervisor
Note This feature is not av
status messages. NEO-4S always reports “ANTSTATUS=OK” whereas LEA-4S will always report
“ANTSTATUS=SHORT”.Bothmessagesshouldbeignore
GPSModules-SystemIntegrationManual(SIM)(incl.ReferenceDesign) ReceiverDescription
GPS.G4-MS4-05007-A1
Page 76

Table of Contents

Related product manuals