Unipower ARR-M Series - Remote Equalize (Optional)

BATTERY CHARGER USER’S MANUAL PART- 2: THEORY OF OPERATION
MCEnPC23-REV.2.4 Page 34
viii. RemoteEqualize(optional)
If Remote Equalize is enabled, the charger will go into “Equalize” mode during a preset time between 1 and 8191
hours, if command is initiated by users via web page, or whenever an external normally open contact closes
momentarily or permanently. For more details, refer to Appendix-5. We can enable or disable remote Equalize via
the external normally open contact as shown on the procedure below:
Figure 37 : External signal to Start Equalize remotely.
Control?
Ok
Next P
r
Exit
Adjust? Level1
Ok Next P
r
Exit
EqStart
Set
Exit
Next
P
r
ON Eq Remote
Set
Exit
Next
P
r
ON
OFF
Out Time
Next
Exit
08
H
:getyou Next till Press
:getyou Next till Press
Next
Exit

-
ON Eq Remote
Figure 38 : Procedure to enable or disable and adjust Remote Equalize.