Unipower ARR-M Series - LED Test; Relay Test

BATTERY CHARGER USER’S MANUAL PART- 2: THEORY OF OPERATION
MCEnPC23-REV.2.4 Page 18
 Acronyms :
Refer to acronym list used for the battery charger at the end of this manual.
7.2.3 Relay test
During relay test, all relays will be energized (or de-energized if you select the fail safe operation option) for 5
seconds; after which the relays will return to their initial status.
Test?Relay
Readings? Level0
RunTest Relay
:getyou Next till Press
secondes 2
duringDisplay
ExitPr Next Ok
ExitPr Next Ok
Figure 17 : Procedure to run Relay Test.
7.2.4 LED Test
During LED test, all LEDs will be lit for 5 seconds; after which the LEDs will return to their initial status.
Test? LED
Readings? Level0
RunTest LED
:getyou Next till Press
secondes 2
duringDisplay
ExitPr Next Ok
ExitPr Next Ok
Figure 18 : Procedure to run LED Test.