Unipower ARR-M Series - Voltage Post-Charge Mode (Optional)

BATTERY CHARGER USER’S MANUAL PART- 2: THEORY OF OPERATION
MCEnPC23-REV.2.4 Page 37
ii. Voltage Post-Charge Mode (optional)
When the Voltage Post-Charge mode is selected, the charger will revert back from Equalize into the Float mode
when the load voltage reaches the Equalize one during a preset time between 1 and 8191 minutes. We can enable or
disable Voltage Post-Charge as shown on the procedure below:
Control?
Ok
Next P
r
Exit
Adjust? Level1
Ok Next P
r
Exit
Eq Stop
Set
ExitNext
P
r
ON VPostChg
Set
Exit
Next
P
r
ON
OFF
Next
Exit
:getyou Next till Press
:getyou Next till Press
Delay
mn 30
Next
Exit

-
ON VPostChg
Figure 41 : Procedure to set Voltage Post-Charge parameters to Stop Equalize mode.