Unipower ARR-M Series - Current Limit Equalize (Optional)

BATTERY CHARGER USER’S MANUAL PART- 2: THEORY OF OPERATION
MCEnPC23-REV.2.4 Page 35
ix. CurrentLimitEqualize(optional)
If Current Limit Equalize is enabled, the charger will go into “Equalize” mode during a preset time between 1 and
8191 hours, whenever the rectifier goes into the current limit for a period of time between 1 and 8191 seconds. We
can enable or disable current limit Equalize as shown on the procedure below:
Control?
Ok
Next P
r
Exit
Adjust? Level1
Ok Next P
r
Exit
EqStart
Set
Exit
Next
P
r
ON ILimEq
Set
Exit
Next
P
r
ON
OFF
Out Time
Next
Exit
08
H
:getyou Next till Press
:getyou Next till Press
Next
Exit

-
ON ILimEq
Delay
S 10
Next
Exit

-
Figure 39 : Procedure to enable or disable and adjust Current Limit Equalize.