To Next Page

To Previous Page

MCEnPC23-REV.2.4 Page 88

ACRONYM LIST

 Flt : Float Mode;

 Eq : Equalize Mode;

 Next : Access to Next menu and sub-menu;

 Pr : Access to Previous menu and sub-menu;

 Ok : Confirm access to active menu;

 Exit : Exit active menu;

 AC : Alternating Voltage / Current;

 DC : Continuous Voltage / Current;

 IBatt : Battery Current;

 VRect : Rectifier Voltage;

 V-/CHASS : Voltage between Negative output and chassis;

 V+/CHASS : Voltage between Positive output and chassis;

 RemTEq : Remaining Time for Equalize;

 ElapsTEq : Elapsed Time for Equalize;

 BoardTemp : Control Board Temperature (Internal Temperature);

 Batt Temp : Battery Temperature;

 VTest : Battery end Voltage reference (Battery Test Mode);

 ITest : Battery discharging Current reference (Battery Test Mode);

 TTtest : Battery discharge Time reference (Battery Test Mode);

 ILim1 : Current Limit for Float Mode;

 ILim2 : Current Limit for Equalize Mode;

 Periodic : For Periodical Equalization;

 LVEq : Low Volt Equalize;

 LCapEq : Low Capacity Equalize

 ACEq : AC

Failure Equalize;

 ILimEq : Current Limit Equalize;

 EqTSecurit : Equalize Time Security;

 VPostChg : Equalize termination with Voltage Post-Charge option;

 IPostChg : : Equalize termination with Current Post-Charge option;

 TPostChg : : Equalize termination with Temperature Post-Charge option;

 VForm : Voltage for Battery Formation Mode;

 IForm : Current for Battery Formation Mode;

 TCompVolt : Voltage Temperature Compensation;

 FS : Fail Safe Mode; Relay coils are de-energized when associated alarms occur;

 NFS : Standard Mode; Relay coils are energized when associated alarms occur;

 EnblCOMRelay : Enable Common Relay (if applicable);

 HVAL1 : Battery High Voltage Alarm level;

 LVAL1 : Battery Low Voltage Alarm level;

 GNDF+ : Positive Ground Fault level;

 GNDF- : Negative Ground Fault level

 Rect. Fail : Rectifier Failure Alarm level;

 HVAL2 : Rectifier High Voltage Alarm level;

 HVSH : High Voltage Shutdown Alarm level;

 LVAL2 : Rectifier Low Voltage Alarm level;

 EnDis : End of Discharge;

 HIntT : Charger High Temperature Alarm level;

 LIntT : Charger Low Temperature Alarm level;

 HExtT : Battery High Temperature Alarm level;

 LExtT : Battery Low Temperature Alarm level;

 ACHV

: AC High Voltage Alarm level;

 ACLV : AC High Voltage Alarm level;

Brand	Unipower
Model	ARR-M Series
Category	Battery Charger
Language	English

Unipower ARR-M Series User Manual

Table of Contents

Questions and Answers:

Unipower ARR-M Series Specifications