Unipower ARR-M Series User Manual

MCEnPC23-REV.2.4 Page 90
LCD MESSAGES LIST
 Soft Start : Battery Charger progressive Start;
 Float : Battery charger in Float mode;
 Equalize: Battery charger in Equalize mode;
 Formation : Battery charger in Formation mode;
 Current Limit1 : Battery charger in Float Current Limit mode;
 Current Limit2 : Battery charger in Equalize Current Limit mode;
 Current Limit3 : Battery charger in Formation Current Limit mode;
 AC OUT : Message in case of AC failure;
 VAC1, (VAC2 & VAC3 for 3 Phase system) : AC Voltage readings;
 IAC1, (IAC2 & IAC3 for 3 Phase system) : AC Current readings;
 IBatt : Battery Current;
 Battery Test Run : The charger is in Battery Test Mode;
 Batt Test Stop : Battery Test Stopped;
 Formation Start : The charger is in Battery Formation Mode;
 Formation Sop : Formation mode stopped;
 Not Available! : Active function not applicable for your system;
 Not Permitted! : Test interrupted because test conditions are not verified;
 Are You Sure? : Confirm active operation;
 Synchro Ok : Synchronization succeeds ;
 Save? : Confirm value modification;
 Reset (…) Ok : Reset operation for active function (…) succeeds;
 Batt High Volt : Battery High Voltage alarm;
 Batt Low Volt : Battery Low Voltage alarm;
 Grou
nd Fault + : Positive Ground Fault alarm;
 Ground Fault - : Negative Ground Fault alarm;
 AC Fail : AC Failure alarm;
 Rectifier Fail : Rectifier Failure alarm;
 Rect High Volt : Rectifier High Voltage alarm;
 HV Shutdown : High Voltage Shutdown alarm;
 Rectif Low Volt : Rectifier Low Volt alarm;
 Charger HighTemp : Charger High Temperature alarm;
 Charger Low Temp : Charger Low Temperature alarm;
 Battery HighTemp : Battery High Temperature alarm;
 Battery Low Temp : Battery Low Temperature alarm;
 AC High Voltage : AC High Voltage alarm;
 AC Low Voltage : AC Low Voltage alarm;
 High Ripple : High Ripple alarm at the DC output;
 Rect Low Current : Rectifier Low Current alarm;
 Rect HighCurrent : Rectifier High Current alarm;
 Batt Low Current : Battery Low Current alarm;
 Batt HighCurrent : Battery High Current alarm;
 High Capacity : Battery High Capacity alarm;
 Low Capacity : Battery Low Capacity alarm;
 PCOM Fail : Communication alarm problem between PCOM (communication board) and control board;
 PM Fail : Communication alarm problem between PM (Measurements board) and control board;
 Frequency Fail : Frequency Failure alarm;
 Defective Cell : Defective cell for unbalanced battery alarm;
 Defective Probe: Defective temperature probe (probe shorted);
 Ba
tt Discharging: Battery is Discharging (Battery is providing current to the load);

Unipower ARR-M Series Specifications

General

Brand	Unipower
Model	ARR-M Series
Category	Battery Charger
Language	English