APX 525/625 Generator Revision C Pre-Installation
©
2005 Del Medical Imaging Corporation
7/5/2005 Page 37
19. Unscrew two rear cover screws (1 in Fig. 11) and remove rear cover (2).
Figure 11. Rear Cover
20. Loosen two stress relief clamp screws (1 Fig. 12).
21. Insert the end of the main cable (2) (P/N 126-0214G2) into the stress
relief clamp until the black insulation on the cable is within the stress relief
clamp as shown in Figure 12.
22. Tighten stress relief clamp screws.
23. Connect white and black wires to corresponding black and white terminals
on TB1 as shown below.
24. Connect ground wire to lug (3 in Fig. 12).
Figure 12. Main Cable Upper Connections
1
2
TB1
3
2
1
To Next Page
Loading...