Maintenance Manual________________________________________________________________
104 _________________________________________________________________ M210886EN-G
Modifying Terminal Display Settings
You can modify the terminal settings with the selections in the Settings
frame of the Terminal panel. The settings define the way sensor messages
and commands are displayed in the Terminal panel.
You can make the following selections:
-Select Visible symbols for binary to show the non-printable
characters (binary values) as symbols.
- Select the VT100 Mode, if you wish the application to emulate a
VT100 terminal.
-Select Local Echo to display the commands you type in the Terminal
panel on the screen. In this case, the commands may be shown on the
screen twice: once by your workstation and once by the field device.
-Select Auto LF to make the system insert a new line on the screen
after each message line that is received from the field device. This
makes it easier to read the field device messages.
-Select Auto wrap to make the system start a new line on the screen
after 80 characters. This way you can see all text on the screen without
having to scroll.
To Next Page
Loading...
Need help?
General
