The Diagnostics function covers
four important areas:
- Inputs
-CAN
- Warn Lamps/Illumination
- Pointer positions
with their support it is possible
to diagnose an existing and
connected configuration.
Inputs means to show all physical
values generated by the connected
Instruments configuration analogous
to the programmed Sensor inputs on
the Master device:
Analog 1-3 (Resistor-sensors),
Current-, Voltage- und Frequency-
Sensors, Output 1 and 2 , Button-
function... The physical unit plus an
Analog-Digital-Converted value is
presented.
CAN shows the data content of 15 x
8 Bytes on the CAN-BUS. Those
represent the information coming
from the different CAN Objects.
June 2009
Training WinGauge Software
page 53
To Next Page
Loading...
