CAN settings, Load CAN Message
and define new CAN Sensor.
The function "CAN Settings" shows up in
various dialogs. This other dialogs can be
opened to get into a more detailed
specification mode for the CAN Sensors.
To configure those Sensors however, very
detailed and specific knowledge about the
Sensors, the environment where they are
used as well as the specific parameters are
required.
Note: Changes to the predefined
Parameters shall only be made, if the
adequate level of knowledge is avail.
June 2009
Training WinGauge Software
page 38
To Next Page
Loading...
Need help?
General
