To Next Page

To Previous Page

A "Level-lever-type-sensor" with a resistor range of 3-180

Ohm has been selected for the Fuel Display. When choosing a

predefined Sensor, all table values "Input" and "Display"

are automatically presetted, as soon as the selection is

confirmed with "OK". At the same time the adequate curve is

displayed beside.

Adjustments to the table values can be made as easy as just override the

presented value in the table above. Be aware of later impact of this change.

June 2009

Training WinGauge Software

page 39

Questions and Answers:

Need help?

Do you have a question about the VDO CANcockpit Series and is the answer not in the manual?

VDO CANcockpit Series Specifications

General