VI.BE.MAC.S.p.A.
pag.27
The following appears on the display:
U P - o n Synchroniser of Thread-puller Position Sensor UP
The INPUT value of the parameter U P is displayed.
Turn the synchroniser on the machine to check that the value changes from o n to o f or viceversa.
Press the down arrow
The following appears on the display:
d n - o f Synchroniser of Needle Position Sensor DOWN
The INPUT value of the parameter d n is displayed.
Turn the synchroniser on the machine to check that the value changes from o n to o f or viceversa.
Press the down arrow
The following appears on the display:
X H - o n X AXIS Sensor
The INPUT value of the parameter X H is displayed.
Lower the jigs and press the HOME key to check if the value changes from o n to o f or viceversa.
Press the down arrow
The following appears on the display:
Y H - o f Y AXIS Sensor
The INPUT value of the parameter Y H is displayed.
Lower the jigs and press the HOME key to check if the value changes from o n to o f or viceversa.
Press the down arrow
The following appears on the display:
E C A Motor Encoder timing A
The INPUT value of the parameter E C A is displayed
Making the machine sew the value changes continuously from ON to OFF.
Press the down arrow
The following appears on the display:
E C B Encoder Motor timing B
The INPUT value of the parameter E C B is displayed.
Making the machine sew the value changes continuously from ON to OFF.
Press the down arrow
The following appears on the display:
C R S on/of Input Alternate Tension Control
The INPUT value of the parameter C R S is displayed with a continual change between ON and OFF.
Press the down arrow key
Display of all OUTPUTS present with the possibility of testing them manually (from 0 1 o to 0 o o)
The following appears on the display:
0 1 o - o f output parameter 0 1 = OFF THREAD-TRIMMER
The OUTPUT value of the parameter 0 1 o is displayed.
Press the D î to change the value from o n to o f
ATTENTION: The coil connected to the output that is called up is also excited automatically. Be extremely
careful to avoid possible malfunctions(Loading carriage / Equipment jigs).
Press the down arrow key
The following appears on the display:
To Next Page
Loading...