VI.BE.MAC.S.p.A.
pag.28
0 2 o - o f output parameter 0 2 = OFF UNLOADER CARRIAGE
The OUTPUT value of the parameter 0 2 o is displayed.
Press the D key to change the value from o n to o f
Press the down arrow to check the various Outputs used:
FUNCTION PARAMETER
0 1 o Thread-trimmer
0 2 o Stacker
0 3 o Tension Releaser
0 4 o Sewing Head External Jig
0 5 o Pressure foot
0 7 o Unloader
0 8 o Jig Re-entry (FUN1) or Loader
0 C o Internal Jig or Loader Jig
Press the down arrow, when the following appears on the display:
0 o o - o f output parameter 0 o = OFF
The OUTPUT value of the parameter 0 o o is displayed.
Press the down arrow key
Display of all signals going from the CPU to the OUTPUTS while the sewing machine is running (from
d 1 o to d o o)
The following appears on the display:
0 1 d - o f output signal 0 1 = OFF THREAD-TRIMMER
The OUTPUT value of the parameter 0 1 o is displayed.
Press the down arrow to check the various Outputs used:
PARAMETER FUNCTION
0 1 o Thread-trimmer
0 2 o Stacker
0 3 o Tension Releaser
0 4 o Sewing Head External Jig
0 5 o Pressure foot
0 7 o Unloader
0 8 o Jig Re-entry (FUN1) or Loader
0 C o Internal Jig or Loader Jig
Press the down arrow, when the following appears on the display:
0 o o - o f output parameter 0 o = OFF
The OUTPUT value of the parameter 0 o o is displayed.
Press the down arrow
The following appears on the display:
P. xxxxx Actual running time in hours from the first start-up of the machine
Multiply the value by ten (Total hours = n° X 10)
Press the down arrow key
The following appears on the display:
M. xxxx Actual sewing time in hours (motor rotation) from the first start-up of the machine
Multiply the value by ten (Total hours = n° X 10)
Press the down arrow key
The following appears on the display:
DU.00x Version of SIMPLE SETTING in use (x = from 1 to 7)
To Next Page
Loading...