Videojet DataFlex 6530 Operator Manual - Rev AA 3-1
Section 3 Main Parts
This chapter contains information about the integral parts and accessories of the printer.
3.1 Equipment Description
The main parts of the Videojet DataFlex 6530 printer are described as follows:
•Printer
• CLARiTY Controller Display
3.1.1 Printer
The Videojet DataFlex 6530 printer uses high-resolution thermal transfer technology with a
unique electronic ribbon drive and printhead control, eliminating the need for compressed air.
The printer has minimal wear parts reducing the maintenance requirements and a quick release
printhead design improves production uptime.
It can print in either of the following modes:
• Intermittent Mode (i.e., while the substrate is stationary)
• Continuous Mode (i.e., while the substrate is moving)
The product is available in either left-handed or right-handed versions to suit different
configurations of the packaging machine.
The product is available in the Standard - 53 mm print width model.
Figure 3-1: Videojet DataFlex 6530 Printer and CLARiTY Controller Display
1. Interconnecting Cable
2. Printer
3. CLARiTY Controller Display
and Power Supply Unit (PSU)
To Next Page
Loading...