4-4 Videojet DataFlex 6530 Operator Manual - Rev AA
Startup
4.3 Starting the Printer
When the printer is switched on, the printer state changes from the SHUTDOWN state to the
STARTING UP state and then to the OFFLINE state. Under this condition, all the external
electrical inputs are ignored and the print sensor signals will not trigger a print. This enables you
to check if the line and the printer are ready for production, before you switch the printer into the
RUNNING state to start printing.
To switch the printer to the RUNNING state, touch .
Figure 4-5 displays the CLARiTY Home Screen with the printer in the RUNNING state.
Note: If the printer has a fault or a warning, RUNNING will be replaced with FAULT or WARNING. If
FAULT is displayed, you must fix the problem before trying to print. Refer "Clearing a Fault
Message or Warning" on page 8-15 for further information.
4.4 Stopping the Printer
To stop the printer from printing, touch . The printer returns to the OFFLINE state.
Figure 4-5: CLARiTY Home Screen in the Running State
To Next Page
Loading...