EasyManua.ls Logo

VIDEOJET DataFlex 6530 - Section 7 Maintenance; 7.1 General Maintenance

Default Icon
123 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Videojet DataFlex 6530 Operator Manual - Rev AA 7-1
Section 7 Maintenance
Introduction
The maintenance of the printer includes the procedures that an operator or a service technician
can perform. This section describes the maintenance tasks that the operators of the printer are
allowed to perform. The other maintenance tasks that only the trained service technicians and
personnel must perform are described in the service manual.
This section provides the information on maintenance task that the operator can perform
General Maintenance
7.1 General Maintenance
Videojet DataFlex 6530 requires minimum ongoing maintenance.
Note: Harsh or dirty environments may require shorter intervals between preventive maintenance
routines.
Do the following inspections and perform the measures as per the scheduled frequency.
CAUTION
EQUIPMENT DAMAGE.
The use of an incompatible cleaning kit can seriously damage your printer. Such damage will
not be covered by your printer warranty. Use only cleaning kits approved by your dealer.
Inspection Check Point Frequency Measures
CLARiTY Display
Check if the touch screen is
clean
As Required Clean the touch screen by wiping
with a dry soft cloth or cotton pad.
Check if the CLARiTY dis-
play surface is clean
As Required Clean the CLARiTY display surface
by wiping with a dry soft cloth or
cotton pad.
Printhead
Printhead With every ribbon
change (minimum
frequency)
Note: Harsh or dirty
environments may
require shorter intervals
between cleaning
Clean with pre-soaked swabs or
wipes that are available from the
approved cleaning kits. For more
information on cleaning the
printhead, refer to “Cleaning the
Printhead and Lightbox” on
page 7-2.
Lightbox With every ribbon
change (minimum
frequency)
Note: Harsh or dirty
environments may
require shorter intervals
between cleaning
Clean with pre-soaked swabs or
wipes that are available from the
approved cleaning kits. For more
information on cleaning the
printhead, refer to “Cleaning the
Printhead and Lightbox” on
page 7-2.
Table 7-1: General Maintenance Schedule

Table of Contents

Other manuals for VIDEOJET DataFlex 6530

Related product manuals