PIPS FOREGROUND T ILE
105
Manipulating the
Foreground Tile
This section explains how to change the position, size, shape, and so forth of the
foreground tile. In each case, do the steps after pressing
PIPS, as described in the pre-
ceding steps. You can do any of these steps while the PIP plays on the Output.
Table 11: Manipulating PIPs Tiles
TO CHANGE TILE… USE OR PRESS… NOTES…
Position
JOYSTICK
Moves tile around screen.
Size (Resizing the tile normally distorts the image it contains.)
T-BAR
Dynamically resizes foreground tile and
its mask. Use the T-BAR to manually
zoom the image while maintaining cor-
rect aspect ratio.
UP ARROW
Increases the height of the foreground
tile and its mask.
DOWN ARROW
Decreases the height of the foreground
tile and its mask.
RIGHT ARROW
Increase the width of the foreground tile
and its mask.
LEFT ARROW
Decrease the width of the foreground tile
and its mask.
SHIFT+0 (zero)
Restore PIP tile to default size, shape, and
position.
Shape
SHAPES
Cycles through available shapes for fore-
ground tile.
SHIFT+SHAPES
Cycles backward through shapes.
n Applies a specific shape to the tile, where
n corresponds to the numbers shown in
the shapes following this table.
Mosaic
SHIFT+OK+T-BAR
Increases/decreases granularity of the
mosaic.
To Next Page
Loading...
