Videonics MXPro DV - Special Key Combinations

INPUT EFFECTS SPECIAL KEY COMBINATIONS
77
Special Key Combinations
Use the following key combinations while working with the Input Effects menu.
When you are not working at the Input Effects menu, use the following key
combinations.
When the Input Effects LED light is lit, Input Effects are enabled. MXProDV applies
the effects according to the parameter values for each effect.
When you use the
SHIFT+INPUT EFFECTS key combination to disable Input Effects,
MXProDV turns off the LED light. It does not change any effects parameter values,
but it does prevent the current Input Effects from being used. Press
SHIFT+INPUT
EFFECTS again to enable them.
Table 7: Input Effects Mode Key Combinations
KEY COMBINATION RESULT
ARROW keys
Moves cursor (or, highlight) between the different Input
Effects.
Numeric Keypad Directly sets the parameter value for the highlighted
effect.
INPUT EFFECTS or OK
Exits from Input Effects mode.
EFFECTS buttons
Moves the cursor directly to that effect – for example,
press POSTERIZE to highlight that effect: press MOSAIC to
highlight that effect: and so on.
If the selected effect matches the currently highlighted
one on the Input Effects menu, pressing the EFFECTS but-
ton increments the effect’s parameter value by one.
SHIFT+0 (zero)
Resets all effects to 0 (off) for the selected channel.
Table 8: Main Mode Input Effects Key Combinations
KEY COMBINATION RESULT
SHIFT+EFFECTS button
Increments the parameter value by one for the selected
effect and applies it to the CURRENT source.
SHIFT+INPUT EFFECTS
Temporarily disables and re-enables Input Effects from
being sent to Program out. See the following paragraph.