Videonics MXPro DV - Demo; Running a Locked Demo

MXPRODV USER GUIDE CHAPTER 7
86
DEMO
Press SHIFT+DEMO to run a demonstration of several MXProDV transitions and other
effects. Demo works in conjunction with the CURRENT and NEXT sources. (If you
have one source selected as CURRENT and NEXT, the demo works with that source
only.) The demo shows many of the effects you can produce with MXProDV.
The demo runs automatically and, upon reaching the end, starts over from the
beginning.
To run the demo:
1 Select the CURRENT and NEXT sources to use for input to the demo.
To use a single source (such as channel A), press
CUT/A and NEXT/A. To use two differ-
ent sources (such as channels A and B), press
CUT/A to make it the CURRENT source,
then press
NEXT/B to make it the NEXT source.
2 Press
SHIFT+DEMO (or, SHIFT+DISPLAY) to start the demo running.
3 To exit from the demo, press any key.
Running a Locked Demo
You can run the demo in locked mode, which prevents it being stopped by pressing
any key on the keyboard. This might be useful for running the demo in a kiosk, a
trade show, or anyplace where someone might interrupt it.
To run the demo in Locked mode:
1 Select the CURRENT and NEXT sources to use for input to the demo.
To use a single source (such as channel A), press
CUT/A and NEXT/A. To use two differ-
ent sources (such as channels A and B), press
CUT/A to make it the CURRENT source,
then press
NEXT/B to make it the NEXT source.
2 Press
LEARN+DISPLAY to start the demo.
3 To exit from the locked demo, press
LEARN+DISPLAY again.