I
NSTALLING
MXP
RO
DV G
ENERAL
N
OTES
35
General Notes
When connecting video and audio outputs from source devices, most of the time
you’ll probably connect to corresponding jacks on the MXProDV rear panel. For
example, if you connect the video to the VIDEO IN jack labeled “1,” you’ll most
likely connect the audio to the AUDIO IN jack also labeled “1.” However, this is not
a requirement. You might use non-corresponding jacks — for example, you might
connect the video from one source to VIDEO IN 1 but connect the audio from the
same source to AUDIO IN 2 if you want to control the audio and video separately.
Remember
, DV devices carry the audio and video signal (as well as a machine con-
trol signal) on the same connection.
To Next Page
Loading...
