Name: Visonic POWERMASTER-10 - INSTALLER GUIDE
Brand: Visonic
Rating: 4 (1 reviews)

To Next Page

To Previous Page

D-302756 61

B. To Configure PGM Lighting Devices in Alarm Conditions and To Set Daytime Limits of Lighting Devices

Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".

Select between "no flash" and "all light flash".

10.

Enter the time at which you wish the lockout state to begin (usually at

dawn).

Note: AM and PM are selected by pressing

and ,

respectively.

11.

12.

13.

Enter the time at which you wish the lockout state to end (usually in the

evening).

Note: AM and PM are selected by pressing

and ,

respectively.

14.

Pressing the or buttons at any stage in the procedure

will take you to “

<OK> TO EXIT

”.

stop – HH:MM

TIME 07:00P

stop – HH:MM

start – HH:MM

FLASH ON ALARM

TIME 07:00A

start – HH:MM

LOCKOUT TIME

no flash



PGM: GENERAL DEF

DEFINE PGM

DEFINE OUTPUTS

Questions and Answers:

Need help?

Do you have a question about the Visonic POWERMASTER-10 - INSTALLER GUIDE and is the answer not in the manual?

Visonic POWERMASTER-10 - INSTALLER GUIDE Specifications

General