Wacker Neuson E3000 User Manual

Tire Safety Information
Bead
The part of the tire that is made of steel wires, wrapped or reinforced by ply cords and that is shaped to fit the
rim.
Bead separation
This is the breakdown of the bond between components in the bead.
Bias ply tire
A pneumatic tire in which the ply cords that extend to the beads are laid at alternate angles substantially less
than 90 degrees to the centerline of the tread.
Carcass
The tire structure, except tread and sidewall rubber which, when inflated, bears the load.
Chunking
The breaking away of pieces of the tread or sidewall.
Cold inflation pressure
The pressure in the tire before you drive.
Cord
The strands forming the plies in the tire.
Cord separation
The parting of cords from adjacent rubber compounds.
Cracking
Any parting within the tread, sidewall, or inner liner of the tire extending to cord material.
CT
A pneumatic tire with an inverted flange tire and rim system in which the rim is designed with rim flanges
pointed radially inward and the tire is designed to fit on the underside of the rim in a manner that encloses the
rim flanges inside the air cavity of the tire.
Curb weight
The weight of a motor vehicle with standard equipment including the maximum capacity of fuel, oil, and
coolant, and, if so equipped, air conditioning and additional weight optional engine.
Extra load tire
A tire designed to operate at higher loads and at higher inflation pressures than the corresponding standard
tire.
Groove
The space between two adjacent tread ribs.
Gross Axle Weight Rating
The maximum weight that any axle can support, as published on the Certification / VIN label on the front left
side of the trailer. Actual weight determined by weighing each axle on a public scale, with the trailer attached
to the towing vehicle.
Gross Vehicle Weight Rating
The maximum weight of the fully loaded trailer, as published on the Certification / VIN label. Actual weight
determined by weighing trailer on a public scale, without being attached to the towing vehicle.
Hitch Weight
The downward force exerted on the hitch ball by the trailer coupler.
Innerliner
The layer(s) forming the inside surface of a tubeless tire that contains the inflating medium within the tire.
Innerliner separation
The parting of the innerliner from cord material in the carcass.

Wacker Neuson E3000 Specifications

General

Electrical Requirements	230 V, 50 Hz
Voltage	230 V
Operating Voltage	230 V
Heat Capacity	3000 W
Fuel Consumption	0.3 l/h
Tank Capacity	12 l
Fuel Tank Capacity	12 l
Heating Capacity	3000 W
Fuel Consumption (l/h)	0.3 l/h
Tank Capacity (l)	12 l
Power Consumption	3 kW