wc_tx001803gb.fm
149
E 3000 Maintenance
8.11 Removing the Oil Burner
Requirements
Power supplies disconnected
Machine cool
Procedure
Follow the procedure below to remove the burner.
1. Disconnect the power supplies.
2. Disconnect fuel lines (a) at the quick-connects.
3. Remove the burner controller (b) to expose the wiring. Label all the wires to
assist in reconnecting.
4. Disconnect all wires coming from the snap switch cable (c) at the burner
controller.
5. Disconnect all wires coming from the burner cable (d).
6. Remove the screws that secure the burner to the machine and maneuver the
burner from the machine.
Result
The procedure to remove the burner is now complete.
wc_gr008595
c
d
b
To Next Page
Loading...
