Wacker Neuson E3000 User Manual

wc_tx002070gb.fm
128
Burner Setup—Gas E 3000
7.7 Checking and Adjusting the Air Damper (Gate) Setting
Requirements  Machine shut down
 Burner cool
Procedure Follow the procedure below to check the air damper setting.
Note: This procedure must be performed at each new job site. The proper setting
depends on environmental conditions at the job site.
1. Shut down the machine and allow it to cool.
2. Remove the burner cover.
3. Loosen the two screws (a) that secure the air adjustment plate (b).
4. Rotate the air adjustment plate so that the proper number on the air adjustment
plate lines up with the setting indicator (c). See topic Factory Settings.
5. Once the air adjustment plate is set, tighten the two screws (a).
Result The air damper setting has now been adjusted.
b
c
a
wcghi_gr005205

Wacker Neuson E3000 Specifications

General

Electrical Requirements	230 V, 50 Hz
Voltage	230 V
Operating Voltage	230 V
Heat Capacity	3000 W
Fuel Consumption	0.3 l/h
Tank Capacity	12 l
Fuel Tank Capacity	12 l
Heating Capacity	3000 W
Fuel Consumption (l/h)	0.3 l/h
Tank Capacity (l)	12 l
Power Consumption	3 kW